Is there such a thing as a 3/4″ T-valve for copper water lines?
A normal 3/4″ brass water ball valve simply turns water through a line on and off. I want to sweat a T into my copper pipes with a valve that will only allow water to flow into one of the two sides [...]
How much is it to have a plumber run a copper water line?
In my unfinished basement (raw ceiling) I have (2) 1″ brass ball valves (hot and cold water) that I want 1″ copper ran about 15′ to an exterior wall then 90′d another 15′ and down the wall (poured concrete) with (2) valves that [...]
Brushed Nickel Kitchen Faucets – Good and Bad
Most kitchen faucet models will fit all kitchen sinks, however there are some exceptions. So it’s a sensible idea to check sizes first. For instance, you will want to determine if the spout length is not too long to prevent the spout from hitting within the sink basin. [...]
Control Valve Properties?
Please link the following to the bottom four characteristics:
1. Butterfly valve
2. Globe valve
3. Ball valve
4. Check valve
A. Less expensive
B. Available in full port design
C. Highest pressure drop
D. Not used in throttling service
1. A
2. C
3. B
4. D
US Auctions
Australian Auctions
Austrian Auctions
Belgian Auctions
Canadian Auctions
French Auctions
German Auctions
Indian [...]
How much should it cost to change the idle air control valve?
I have a 98 Ford Contour. I’ve had it to the dealer a couple years ago because of the check engine light, after paying a fortune (smoke test) they told me my gas cap wasn’t on tight. Now they say it will cost over [...]